simple

TH 6×4 Gas Traditional Utility Vehicle (Pre-Order Now)

  • Top of the line heavy duty work vehicle
  • Best in class work capability
  • Wide stance for enhanced stability
Ship to store/home

Engine (shield removed for illustration)

The Gator™ TH 6X4 Utility Vehicle is powered by an 11.6-kW (15.5-hp)*, 675-cc (41.2-cu in.), air-cooled, V-twin, four-cycle gas engine.

 

*The engine horsepower information is provided by the engine manufacturer to be used for comparison purposes only. The actual operating horsepower will be less.

Engine features

 

This engine has several performance and reliability features:

  • Overhead valve design for greater efficiency and fuel economy
  • Full-pressure lubrication system with standard filter
  • Replaceable single-element air cleaner with remote intake
  • Large-capacity spark-arresting muffler
  • Electronic ignition for less service and fast, reliable starts
  • Low fuel consumption and large 18.9 L (5 U.S. gal.) fuel tank
    • Fuel consumption at half load and average speed is as follows:
      Gator TH 6×4: 1.3 L/h (0.35 U.S. gph)
  • Engine is Environmental Protection Agency (EPA) compliant

Gator TH 6X4 drive system

The Gator™ TH 6X4’s power is transmitted from the transaxle to the center axle. The rear axle is driven by roller chains from the center axle.

 

1. High flotation tires
2. Transaxle
3. Chain drive
4.  Engine
5. Variable-speed drive

Key elements of the drive system are as follows:

Variable-speed drive

 

The variable-speed drive consists of two clutches connected by a drive belt:

  • Drive clutch is attached to and rotated by the engine.
  • Driven clutch is attached to and drives the transaxle.

Features include:

  • Infinite selection of speeds (0 km/h to 32 km/h [0 mph to 20 mph])
  • No shifting necessary as operator increases speed
  • Adjusts speed to the load to avoid bogging down when going up a hill or through challenging conditions because the wrong gear was selected

Variable-speed drive

 

1. Idle speed
2. Moderate speed
3. High speed
4. Drive clutch
5. Driven clutch

Here is how the variable-speed drive works:

  1. As the engine speed increases, the spring-loaded drive clutch is closed by weights being forced out by centrifugal force.
  2. As the drive clutch closes, the belt rides up to the largest diameter of the drive clutch and forces open the driven clutch.
  3. With the belt running in the smallest diameter of the driven clutch, the speed being transferred to the transaxle is increased.
  4. The driven clutch is designed to sense varying loads (inclines, mud, etc.) and constantly adjusts the drive speed upward or downward, so the engine rpm remains constant at constant throttle position.

Transaxle

 

The transaxle is fully enclosed and runs in oil for reliability.

Helical gears are used for quiet operation.

The differential design reduces scuffing of the turf during turns because the inside wheels turn slower than the outside wheels (vehicles that have a solid axle shaft must skid the inside wheel when making a turn).

Traction assist (differential lock) is built into the transaxle:

  • Allows locking the rear drive wheels together
  • Provides increased traction in tough spots

The neutral start safety interlock is provided for the engine ignition system.

 

Bolt-on cast-aluminum rear axle housings provide an extremely strong supporting structure.

  • Large, sealed bearings are located inside the housing for better protection
  • Forged-splined shaft for increased torsional strength

Side-by-side bucket seating

Numerous features offer the operator and passenger a comfortable ride and provide many operating conveniences.

  • Side-by-side bucket seating provides room for one operator and one passenger
  • Hip restraints serve as a handhold and help to keep the operator and passenger in their seats over rough terrain
  • Both seats tilt forward for dry storage and ease of service
  • Choice of adjustable or non-adjustable driver’s seat
  • Hour-meter is standard to assist in maintaining regular service intervals
  • Integrated cupholders
  • 12-V outlet located on instrument panel

Convenient walk-through operator station

The control location and walk-through platform provide easy entry/exit for operator and passenger.

NOTE: Shown above with the optional front bumper, brush guard, front fender guard, and floor mat.

 

NOTE: The front bumper is standard on the Gator™ TH 6X4 Diesel.

  • All models feature a park brake indicator light, hour-meter, and tank-mounted fuel gauge as standard equipment
  • Traction assist (differential lock) is hand operated and conveniently located between the operator and passenger seats
  • Traction assist indicator light (Gator TH 6X4 only)
  • Glove box is located in the dash to provide a convenient storage area for small tools and the operator’s manual
  • Grab bar is provided for the passenger
  • Center-mounted key switch
  • Additional storage is provided between the seats

Deluxe cargo box (TX 4X2 shown)

Deluxe cargo box, tailgate lowered (TX 4X2 shown)

The deluxe cargo box side panels and tailgate consist of a 15 percent glass-filled polypropylene composite material that eliminates rust and dents and reduces noise. The cargo box floor and load guard (front panel) are made of steel.

Deluxe cargo box tailgate

Tailgate handle

Tailgate lowered to 150 degrees

The tailgate can be opened or removed for easier cleanout and to carry longer items. The tailgate features a truck-like latch, and can be operated with one hand.

 

The standard installed lanyards can also be removed to lower the tailgate to 150 degrees for convenient loading and unloading tasks.

Deluxe cargo box tilt

Integrated handle (B) and latch (A)

Gas assist (C) and prop rod (D)

The deluxe cargo box is easier to latch (A), unlatch, raise, and lower with the integrated handle design (B) and gas assist (C).

 

A prop rod (D) is provided to hold the box in the upright position for operator convenience, as well as limit box pivot travel.

Integrated tie-down points

Integrated tie-down point in cargo box bed

Additional tie-down points on cargo box

The deluxe cargo box offers integrated tie-down points for increased versatility. Tie-down points are located in the following areas:

  • Four corners inside the cargo box bed
  • Four points on the load guard directly behind the operator station (A)
  • Tie-down bars on either side of the cargo box (B)
  • Six points on the underside of the cargo box frame (circled)
Converting deluxe cargo box to a flat bed

Deluxe cargo box converted to a flat bed

The deluxe cargo box easily converts to a flat bed by removing ten bolts and unplugging rear lights (if equipped) at the harness pigtail at the rear of the machine. The flatbed configuration allows loading irregularly shaped cargo.

Optional accessories

Brake and taillight

Bedmat—protects the steel floor from dents

Optional accessories for the deluxe cargo box include:

  • Factory-installed brake and taillight
    • Brake and taillight only (for back-up lights, flashers and turn signals, order deluxe light kit)
  • Factory-installed spray-in liner (not shown)
    • Improves skid resistance and surface abrasion protection
  • Cargo box bed mat
  • Cargo box power lift (not shown)
Specifications
 

Box capacity

Volume

465 cu L
(16.4 cu ft)

Weight
TH 6X4 gas

454 kg (1000 lb)

Weight
TH 6X4 diesel

550 kg (1200 lb)

 

 

Box dump angles (degrees)

Manual dump

43 degrees +/-1

Power dump

43 degrees +/-1

 

Cargo box load height

63.5 cm (25 in.)

 

The cargo box load height allows for easy loading and unloading.

CAUTION: Carrying extra-long cargo that extends beyond the box can adversely affect stability.

  • Top of the line heavy duty work vehicle
  • Best in class work capability
  • Wide stance for enhanced stability

Key Specs

Engine power
11.6* kW
15.5* hp
Cargo box dimensions
1143 x 304.8 x 1320 mm
45 x 12 x 52 in.
Cargo box capacity
544 kg
1200 lb
Towing capacity
635 kg
1400 lb
Front suspension
Independent spring over shock, single A-arm
Rear suspension
Two high-floatation, low pressure tires (solid axles)
Final drive
Fully enclosed, oil bath
Four wheel drive
Fuel capacity
5.0 G listed in the Sales Manual

Engine

Type
4 cycle gas
Displacement
675 cc
41.2 cu in.
Power
11.6* kW
15.5* hp
Cooling system
Air

Drivetrain

Transmission
Continuously variable transmission (CVT)
Final drive
Fully enclosed, oil bath
Four wheel drive
Traction assist
Mechanically Activated Differential Lock
Descent control
No

Suspension

Front
Independent spring over shock, single A-arm
Rear
Two high-floatation, low pressure tires (solid axles)

Brakes

Type
Wet disk in transaxle
Park brake
Wet disk, hand operated

Tires

Front
Two 22.5×10.00-8, 2 PR hi-flotation
Rear
Four 25×12.00-9, 2 PR hi-flotation

Dimensions / Capacities

Wheelbase
79 (2006 mm) front to rear, 26.8 (680 mm) mid to rear
Front tread centers
1270 mm
50 in.
Rear tread centers
1220 mm
48 in.
Vehicle weight
493 kg
1087 lb
Height
1108 mm
43.6 in.
Width
1525 mm
60 in.
Length
2642 mm
104 in.
Ground clearance
6.0 in (transaxle) 9.8 in (foot platform)
Fuel capacity
5.0 G listed in the Sales Manual
Cargo box dimensions
1143 x 304.8 x 1320 mm
45 x 12 x 52 in.
Cargo box capacity
544 kg
1200 lb
Payload capacity
635 kg
1400 lb
Towing capacity
635 kg
1400 lb
Hitch
1.25in (optional) listed in the Sales Manual

Features

Color
Green/Yellow
Power steering
No
Battery
340 Cold Cranking Amps @ -18C (0F)
Alternator
16.6 Amp @ 3700 rpm (regulated)
Instrumentation
Fuel Gauge, Hour Meter listed in the Sales Manual
Storage
Cup holders, Glovebox
Seating
Bucket Seats

Additional information

Country of Manufacture
U.S.
Date collected

MYGREENWAY

Order parts, view your invoices, or request equipment services.

portal login

Customer Support

We’ve opened a Customer Contact Center to help you with all your Greenway needs!

Call (888) 237-7447
Powered by SIEQ