Drives:
- Check Main Gear Case Levels
- Check Alignment of Drive and Driven Sprockets
- Check PTO Driveline and Shields
- Check PTO Shear Bolt on Slip Clutch
Pickup:
- Check Drive Belt and Idler
- Check Slip Clutch Torque (Mega or Mega Wide)
- Check Auger Scrapers
- Check Strippers
- Check Teeth
- Check Tooth Endplay
- Check Compressor Rack and Rods
- Check Pickup Height Adjuster
- Check Cam and Cam Bearings
- Check Float Springs
- Check Gauge Wheels, Tires and Hubs
- Inspect Rotor Strippers
Automatic Twine Wrapping System:
- Check Twine Arm and Drive Gear
- Check and Adjust Twine Electric Actuator
- Check Voltage
- Check Twine Arm Timing
- Check All Twine Arm Adjustments
- Inspect Twine Arm Washers
- Inspect Twine Guides
- Check Twine Tension Plates
- Inspect Twine Indicator
- Check Twine Cutter Tension
- Check and Adjust Twine Cutter Knife
- Check Knife Travel
- Check Twine Wrap Sensor
- Check and Adjust Knife and Anvil
Automatic Net Wrapping System:
- Check Feed Roll Brake
- Inspect Rubber Feed Roll
- Check Knife and Knife Travel
- Check Operation of Monitor
- Check Actuator
- Check Voltage
- Check V-Belt and Idler
- Inspect Steel Rolls for Pits or Rust
Rolls:
- Check # 9 Roll Scraper
- Check Stagger Roll Scraper (High Moisture)
- Inspect Starter Roll and Bearings. Roll #1
- Inspect Lower Belt Drive Roll and Bearings. Roll #2
- Inspect Front Idler Roll and Bearings. Roll #3
- Inspect Upper Belt Drive Roll and Bearings. Roll #4
- Inspect Front Tension Arm Idler Roll and Bearings. Roll #5
- Inspect Top Arm Roll and Bearings. Roll #6
- Inspect Upper Rear Gate Roll and Bearings. Roll # 7
- Inspect Lower Rear Gate Roll and Bearings. Roll # 8
- Inspect Lower Gate Roll and Bearings. Roll # 9
- Inspect Rear Tension Arm Idler Roll and Bearings. Roll # 10
- Inspect Top Idler Roll and Bearings. Roll # 11
- Inspect Center Tension Arm Idler Roll and Bearings. Roll # 12
- Inspect Belt Staggering Roll and Bearings. Roll # 13
Monitor and Electrical:
- Check Gate Latch Switches
- Check Oversize Bale Switch
- Check Bale Size Switch
- Check Wrapping Cycle Switch
- Check Bale Switch
- Check Bale Counter
- Check Monitor Lights, Gauges, and Alarm
- Check Electrical Harnesses
- Check Bale Diameter Sensor
- Check Bale Shape Sensors
Belts:
- Check Belt Tracking
- Check Starter Roll Scraper
- Check Belt Tread
- Check Lacing and Pins
Hydraulics:
- Check Bale Density Valve
- Check Bale Density Gauge
- Inspect Tensioning Cylinder and Hoses
- Check Gate Latch Linkage
Safety:
- Inspect PTO Shields
- Inspect Shields and Latches
- Inspect SMV Emblem
- Inspect Fire Extinguisher
- Check All Decals
- Inspect Warning Lights
- Inspect Safety Chain
- Inspect Parking Stand
Miscellaneous:
- Inspect Tires, Wheels, and Hubs
- Check Tension System Chains, Springs, and Sprockets
- Inspect Gate Hinges
